Home » Shopping » Heating » Heat Exchanges
 |
| |
HEAT EXCHANGERS
Please find Boiler connectors for connection to your Boiler at bottom of this page.
By utilising a Heat Exchanger you can create the most economical and efficient way to heat a swimming pool or a Koi pond. Linked to a boiler, the heat is transferred to the pool via the heat exchanger. The final selection of a heat exchanger should be ascertained by pool capacity, boiler output, heat retention properties and positioning of equipment. The output specification of the heat exchanger is the maximum that may be reasonably expected the unit to produce, so it is therefore highly recommended to upgrade to the next output size if in any doubt.
It is important that the correct rated boiler is used for the size and gallonage of the pool and that the flow rates are not exceeded. The maximum flow rates for the primary and secondary circuits are stated on the label fixed on the front of the boiler along with the relevant rating of that specific heat exchanger.
All the units are designed for wall mounting and the design incorporates an internal finned primary heating element for maximum efficiency. Manufactured from quality marine grade Type 316 stainless steel, each unit undergoes 12 stringent tests during quality control production. Each unit is tested to 70 p.s.i before leaving the factory and each one is guaranteed for a full 12 months from purchase date, subject to essential conditions are strictly followed during the installation and working life.
Maintenance Notes: Please note that some of these requirements are relative to swimming pool installations as well as Koi pond installations.
All units must be installed vertically. Care must be taken to insure that no chemical residue can enter the heat exchanger when the system is not running. It is recommended to maintain a constant pH between 7.2 - 7.6 to prevent excessive scaling deposits and corrosion.
When chemical treatments to the pool or pond take place, the treatment should take place as far downstream to the unit as possible. Where possible prohibit the flow through the exchanger until some chemical dispersion has taken effect, and preferably before re-circulating through the heating system again.
INSTALLATION
 It is paramount that the unit is installed upright ; with the primary boiler flow from bottom to top.
The secondary flow, water from Pond (usually after filtration), is then connected to the top side entry and exits at the lower side outlet before returning to the pond.
The above cannot be stressed strongly enough please See Generic representation below it illustrates just how important this is.
All threaded connections are BSP thread. We are able to supply these fittings from stock and are available in a number of sizes and materials. See pond plumbing
Please goto bottom of this page for primary side connectors for connecting to your Boiler.
Heat exchangers are classified according to their flow arrangement. In parallel-flow heat exchangers, the two fluids enter the exchanger at the same end, and travel in parallel to one another to the other side. In counter-flow heat exchangers the fluids enter the exchanger from opposite ends. The counter current design is most efficient, in that it can transfer the most heat. 
|
|
 |
 BTU: 60,000
COILS: Single-Coiled
POND SIZE: 3000 Gallons
Flow Rate: 900 GPH
|
BTU: 100,000
COILS: Single-Coiled
POND SIZE: 5000 Gallons
Flow Rate: 1440 GPH
|
BTU: 130,000
COILS: Single-Coiled
POND SIZE: 6500 Gallons
Flow Rate: 1860 GPH
|
BTU: 170,000
COILS: Single-Coiled
POND SIZE: 8500 Gallons
Flow Rate: 2460 GPH
|
BTU: 230,000
COILS: Single-Coiled
POND SIZE: 11500 Gallons
Flow Rate: 3300 GPH
|
BTU: 460,000
COILS: Double-Coiled
POND SIZE: 23000 Gallons
Flow Rate: 8580 GPH
|
| Heating Exchange Connector |
 HEATING EXCHANGE CONNECTOR
For use with single coiled units for the primary flow and return to the boiler
|
 For use with double coiled units for the primary flow and return to the boiler. Also has a built in tap to isolate water flow.
|
|
Basket total: £0.00
Shop Departments Air Accessories Air Pumps Aquarium Products Auto Feeders Books Videos and Gifts Electrical Evolution Aqua Filtration & Media Food Heating Japanese Maples+Bonsai Koi Handling Medications Ozone Pond Additives & Treatments Pond construction Pond Plumbing Quaranteen & Vats Thermometers U V Clarifiers Used Items Vacuums/Accessories Water Pumps Water Testing Water/filters/Meters
Koi All koi (57) Lastest Shipment (54) Sold Koi (198) Tosai (52)
Varieties Algoromo (1) Asagi (1) Benigoi (1) Goshiki (3) Hariwake (1) Kohaku (5) Komonryu (1) Kujaku (3) Sanke (10) Shiro Utsuri (11) Showa (11) Shusui (2) Tancho (3) Tancho Sanke (3) Yamatonishiki (1)
|
